D-LINK ANT24-0600 Indoor Gain 6dBi WiFi Range Extender Antenna RP-SMA Connector
**NEW ORIGINAL RETAIL BOX BRAND**
The ANT24-0600 2.4GHz Directional Antenna is a range extender antenna that provides output 2 to 2.5 times higher than that of the 2dBi dipole antennas normally bundled with wireless LAN devices.
This directional antenna is suitable for indoor use only and can substantially improve signal transmission strengths* at sites where the default antenna of the wireless device is weak due to environmental or structural condditions.
The ANT24-0600 antenna works with all access points and remote routers equipped with an RP-SMA or RP-TNC connector. Installation is a simple two step process and can be done in a few minutes.
The ANT-24-0600 antenna offers several mounting options, it can be placed on a flat surface, such as on a desktop, mounted flat against a wall, or attached vertically to a flat surface, such as a metal door, using its magnetic mounting base.
The antenna design provides a focused wireless signal with 80 degree spread, allowing it to be tilted to a desired angle to produce the most effective signal transmission result.
вЂў 2.4GHz to 2.5GHz from
вЂў 50 ohm
вЂў 1.92 max.
вЂў 10 dB max.
Design of the antenna
вЂў 1 / 2 dipole antenna array of symmetric oscillators
Maximum gain (no attenuation in the cable)
вЂў 6.0 dBi@2.45Р“Р“С† (typical)
вЂў 1 W
Attenuation in the cable (1.5m)
вЂў 2.1dB @ 2.45GGts
Diagram in the horizontal plane
вЂў 3dBi, 68
Diagram in the vertical plane
вЂў 3dBi, 80
вЂў Filotex 50 ohm
Base of the antenna
вЂў Panel: 80 x 80 x 15.6 mm
вЂў Base: 85 x 65 x 34 mm
вЂў 202 grams (antenna only)
вЂў From-20o to 65o C
вЂў From-30o to 75o C
вЂў Antenna ANT24-0600
вЂў Cable length 1.5m Filotex
вЂў RP-SMA connector
вЂў The adapter RP-SMA to RP-TNC
вЂў Quick Installation Guide
вЂў 2 screws
вЂў 2 plastic mounting
Write a review
Note: HTML is not translated!
Rating: Bad Good
Enter the code in the box below: